C& e Auto Tech

MOBILE
PROGRAMMING

kenelliott@ceautotech.com

              Pre Programming Steps (Toyota, Lexus, Scion Modules)

714 356-7481

       Go With God



A CHECK LIST OF ITEMS AND PROCEDURES

THAT MUST BE FOLLOWED BEFORE

CALLING C & e FOR A PROGRAMMING

SERVICE CALL ON TOYOTA, LEXUS, SCION VEHICLES


(PLEASE READ AND CHECK OFF EACH ITEM)

CALL IF YOU HAVE ANY QUESTIONS




Toyota, Lexus, Scion PCM and TCM Modules

  •     You are ultimately responsible to have the correct module for the vehicle.             

               OEM Rebuilt is the best choice, C & e has seen 0 defective units in ten years. 

         

         C & e has good success programming Used units (if its the right part for that vehicle).

          

           Aftermarket Rebuilt Modules have a very high failure rate. C & e no longer

          programs Aftermarket Rebuilt modules. C & e had 36 defective units in 2014.

       

               PCM and TCM Modules


          When replacing the PCM (new or used) have all Ignition Keys with vehicle.

               When replacing a Used PCM a security code is required. Call for prices.

                             

               General instructions all Powertrain Modules

  •   Save all Information Sheets packaged with replacement modules.


  •   Make sure data and codes can be read with a scanner not a code reader before

          making a programming appointment with C & e. The module has  to be powered

          up and communicating before it can be programed.


  •     Check the condition and state of charge of the Battery.
  •    Battery cables must be clean and tight.
  •      Vehicle must be parked close to a 110v wall outlet.
  •    Should be parked in the shade with the windows down. Setting in the sun with

                the windows up, tempters can reach 140 degrees.  

   

Toyota, Lexus, Scion Body, ABS, IPC and other Modules


  •   C & e will only Initialize OEM New or OEM Rebuilt Modules, no used units.                                                                      

   

     Only the ABS and Immobilizer needs Initializing. Others are Plug and Play

          

      ABS Module

      If steering wheel is not straight, align vehicle before calling C & e. Otherwise Codes may set.

      Immobilizer Module

      All Ignition Keys must be with vehicle.   


      General Instructions all Modules     

  •   Verify communication with module before calling C & e for a programming appointment.
  •     Save all Information Sheets that are packaged with replacement Modules.
  •   Check the condition and state of charge of the Battery.
  •   Battery cables must be clean and tight.
  •   Vehicle must be parked close to a 110v wall outlet.
  •   Should be parked in the shade with the windows down. Setting in the sun with

          the windows up, tempters can reach 140 degrees.