Go With God





  A CHECK LIST OF ITEMS AND PROCEDURES
THAT MUST BE FOLLOWED BEFORE
CALLING C & e FOR A PROGRAMMING
SERVICE CALL ON CHRYSLER AND JEEP VEHICLES

(PLEASE READ AND CHECK OFF EACH ITEM)
CALL IF YOU HAVE ANY QUESTIONS


           Warning;

           Caution 2004 and newer Vehicles may have CAN Networking, do not install
        any modules out of another vehicle. This includes Aftermarket Rebuilt Modules.
        One ignition key on cycle and other modules may reconfigure. These modules
        will now require replacement, programming will not salvage them. Click on Critical
        Chrysler Jeep information link for details.   



     

  •   Some OBD I modules have to be Programmed, call for details.


  •    OEM Rebuilt is the best choice, C & e has only seen 2 defective units last year. 

          C & e has good success programming Used units (if its the right part for that vehicle).

        

  •   Aftermarket Rebuilt modules have a very high failure rate. 

           C & e will no longer program Aftermarket Rebuilt Modules. 36 failed in 2014.

     

        Special Instructions on TIPM Module

       When replacing the TIPM, call for special instructions. TIPM will be

      damaged it they are not diligently followed. (IMPORTANT) call

      Ken at 714 356-7481 before connecting the Battery with a new TIPM.


         Special Instructions on Diesel PCM

      Note special steps must be followed on the Diesel vehicles listed below;
        Ram w6.7 L
        Jeeps w3.0 L or w2.8L
        Sprinter w2.7L                                                                               
     1.When replacing the PCM the original PCM must be installed allowing

        information to be stored "inhaled into scanner"  then exhaled into new PCM

      2.Important, verify you can communicate with original PCM with a Scanner not

         a Code Reader. If no communication can be established call Ken at 714 356-7481
         before making a programming appointment.      


       



       All other Powertrain and Body modules (except TIPM and Diesel PCMs).  


  •   Install the replacement module and have the old module with vehicle.

                Save all Information Sheets packaged with replacement modules.


  •   Make sure data and codes can be read with a scanner not a code reader before

          making a programming appointment with C & e. The module has  to be powered

          up and communicating before it can be programmed.

     

  •   Check battery for condition and state of charge.   
  •     Battery cables must be clean and tight.
  •    Vehicle must be near a 110v outlet.  
  •     Try to park vehicle in the shade with windows down, a vehicle parked in the sun with

                the windows up can get up to 140 degrees.




   C& e Auto Tech

MOBILE
PROGRAMMING

714 356-7481

kenelliott@ceautotech.com

        Pre Programming Steps (Chrysler and Jeep Modules)